Ribbed Belt Pulley With Freewheel, Removing And Installing: Installing

Install in reverse order of removal. Note The Following  :

The :VAG1332  must be rearranged for installing the decoupling belt pulley with freewheel as follows:

-- Release the insert -1- and remove it from the handle part -2-.

Fig 1: Identifying Torque Wrench Socket Drive Grip

Courtesy of AUDI OF AMERICA, LLC

-- Turn the handle part -2- of the torque wrench 180° and reinsert the socket.

-- Set the rotation direction of the torque wrench socket to "left".

-- Next, screw the ribbed belt pulley with freewheel by hand onto the generator shaft until stop.

-- Install the :T10474  -1- ribbed belt pulley with freewheel and attach the wrench.

-- Place a suitable tool -2- in the generator shaft.

Fig 2: Identifying Suitable Tool

Courtesy of AUDI OF AMERICA, LLC

-- Turn the generator shaft using the :VAG1332  -3- counter clockwise to tighten the ribbed belt pulley with freewheel.

-- Clip protective cap onto generator pulley.

Tightening Specification