Battery -A-, DISCONNECTING AND CONNECTING, 0K2: Connecting

Fig 1: Connecting Battery

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- from the Battery Monitoring Control Module -J367- -3-.

-- Attach the battery ground cable clamp by hand to the battery negative terminal "-" and tighten the nut -1-.

-- Reconnect the connector to the Battery Monitoring Control Module -J367-.

When the battery is reconnected, the following steps must be performed:

• Activate the power window regulator one-touch up/down function. Refer to the Owner's Manual.
• Check DTC memories of all control modules and delete the displayed entry "Undervoltage" using the Vehicle Diagnostic Tester.

TIP:

After reconnecting the power supply, the ESP warning lamp can only go out after the vehicle has been driven a few meters.

Tightening Specifications 

• Refer to OVERVIEW - Battery -A- INSIDE ENGINE COMPARTMENT (0K2)