LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Audi >> 2021 >> A4 Quattro Premium Plus, 2.0L Eng VIN B >> Repair and Diagnosis >> Quick Lookups >> Technical Bulletins >> Technical Service Bulletins >> Other Variant >> Window Motors & Regulators >> 92 Windshield Washer System Pump Inoperative And/Or Leaking B126101, B126111, B126113 (GROUP 92, NO. 22-31)

92 Windshield Washer System Pump Inoperative And/Or Leaking B126101, B126111, B126113 (GROUP 92, NO. 22-31)

WARNING: This page is about the A4 Quattro Premium, 2.0L Eng VIN A, which is a different variant/trim than selected.
Publication date: 2022-07-14
Reference number: GROUP 92, NO. 22-31
Supersedes refnos: 2067557, 2067557/1

92 WINDSHIELD WASHER SYSTEM PUMP INOPERATIVE AND/OR LEAKING B126101, B126111, B126113

92 WINDSHIELD WASHER SYSTEM PUMP INOPERATIVE AND/OR LEAKING B126101, B126111, B126113

TECHNICAL SERVICE BULLETIN

Reference Number(s): GROUP 92, NO. 22-31 (2067557/1), Date of Issue:  July 14, 2022
AUDI: 2019-2024 All Audi Vehicles
GROUP: 92 - Windshield Wiper and Washer System

SERVICE INFORMATION

92 22 31 2067557/1 July 14, 2022.

APPLICABLE MODELS AND YEARS

Model(s) Year VIN Range Vehicle-Specific Equipment
All Audi Vehicles 2019 - 2024 All Not Applicable

CONDITION

Customer states: 

The customer reports a windshield washer system that is inoperative and/or a windshield washer solvent leak.

Workshop findings: 

One or more of the following DTCs are stored in the Control Module BCM, J519 (address word 0009). They may be either static or sporadic:

Either symptom is easily reproduced.

TECHNICAL BACKGROUND

If the window washer pump becomes blocked due to frozen washer fluid, the resistance in the pump exceeds the upper limit. As a result, one or more of the DTCs above may be stored in the Control Module BCM, J519 (address word 0009).

PRODUCTION SOLUTION

A production solution is in development.

SERVICE

Additional information concerning the nature and root cause of this pump failure is necessary in order to proceed in the fault-solving process. The following directions will aid in finding the root cause.

  1. Perform a functionality check of the windshield washer pump. If it is inoperative, check for any of the diagnostic entries specified in this TSB in the BCM (DA 0009). If one or more of the above DTCs are stored, a hard reset may be necessary in the BCM before these DTCs can be erased. Once erased, perform a functional check of the windshield washer pump once again. Should any of the DTCs return and the windshield washer pump continues to be inoperative after a functionality check, complete the ODIS test plan in its entirety. Proceed as directed by the test plan.
  2. Check the type and composition of the windshield washer solvent currently in the reservoir. Refer to TSB 2038151 92 Washer solvent level warning is on  for the correct type and concentration of the washer solvent. A freezing event may have occurred and caused damage to the windshield washer pump due to the addition of solvent with insufficient freeze protection. If the washer solvent currently in the reservoir does not conform to these specifications, please report the type and concentration of the currently installed washer solvent in the claim comments. If the type and concentration of the windshield washer solvent is incorrect, the reservoir must be emptied of its contents and the solvent replaced with the correct type and concentration, as specified. Counsel our customer on the washer solvent being used and stress that the incorrect type and concentration will damage the washer system components.
    NOTE: An inoperative windshield washer pump may not be replaced until a GFF test plan has been completed in its entirety for the DTCs that recur, directed by the test plan to replace the windshield washer pump, and the completed test plan uploaded to GFF Paperless
  3. In cases where no DTCs are stored in the BCM but the windshield washer pump is visibly leaking, the pump may be replaced without the need for a test plan. Take a photo showing the leak in the pump and post it to DOC-IT.

WARRANTY

This TSB is informational only and not applicable to any Audi Warranty.

ADDITIONAL INFORMATION

The following Technical Service Bulletin(s) will be necessary to complete this procedure:

All parts and service references provided in this TSB (2067557) are subject to change and/or removal.

©2022 Audi of America, Inc.  All rights reserved. The information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of Audi of America, Inc., its affiliated companies, and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites without the prior expressed written permission of the publisher.