Brake Caliper, Replacing, Steel Brakes 1LA/1LB: Installing
Install in reverse order of removal and note the following:
- Clean the bolts and nuts before reusing.
- Replace damaged bolts and nuts.
- Replace the self-locking bolts and nuts after removal.
-- Install the brake pads. Refer to BRAKE PADS, REMOVING AND INSTALLING, STEEL BRAKES 1LA/1LB .
-- Bring the brake hose into the installation position and tighten the union bolt -arrow-.
- Make sure the brake hose is routed correctly.
- Make sure the brake hose is not blocked, bent, twisted or rubbing against the vehicle.
-- Remove the Brake Pedal Actuator :VAG1869/2 .
-- Only bleed the brakes on the wheel from which the brake caliper and the brake hose was loosened. Refer to HYDRAULIC SYSTEM, BLEEDING .
- If the brake pedal still feels "soft", completely bleed the brakes. Refer to HYDRAULIC SYSTEM, BLEEDING .
-- Check brake fluid level, and fill if necessary.
Faulty brakes increase the risk of an accident.
- Make sure the brakes are working correctly before driving the vehicle for the first time.
-- With the vehicle stationary, firmly press the brake pedal several times so that the brake pads in the operating condition properly sit in their respective position.