Brake Pad Anti-Friction Plates And Clamps, 1LC/1LD/1LE/1LF/1LH
There are Four Anti-Friction Plates -A- Installed in Every Brake Caliper.
All four anti-friction plates must be installed on the brake pad contact surfaces as shown.
Note the correct installation position for the four anti-friction plates.
The narrow small tab points to the inside of the brake caliper.
Check for the correct installation position after each removal and before installing the brake pads.
Clamp -image A: 1- for Brake Pads -image B: 2- on the Rear Side of Brake Caliper
The clamp spring -image A: 1- is inserted at the bottom and engages in the brake caliper mount.
The clamp must be pushed through the mounts on both brake pads -image B: 2-.
The clamps must lock audibly and noticeably in the mount in the brake caliper.
Make sure the installation position is correct after every removal / installation of the brake caliper and after the installation of the brake pads.