SUBFRAME CROSSBRACE, Removing And Installing: Notes
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm:VAG1331
- Engine and Gearbox Jack:VAS6931
- Rear Axle Support:T10552
- Puller - Ball Joint:T40043
- Strut:T40335
- Locating Pin:T40334
- Mount:T40386 , not illustrated
Tools, Preparing
-- Loosen the bolts -arrows-.
-- Adjust the dimension -a-.
- Dimension -a- = 250 mm
-- Tighten the bolts again.
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Subframe Crossbrace to Subframe
- Bolts - Subframe Crossbrace/Steering Gear to Subframe
- Bolt - Clip to Subframe Crossbrace