Stabilizer Bar, Removing And Installing: Installing

Install in reverse order of removal and Note The Following:

NOTE:

There must be no grease on the stabilizer bar and rubber bushing.

If a stud bolt for the clamp has loosened, tighten it all the way.

-- Install the threaded connections for the stabilizer bar only until the stop, but do not tighten yet.

NOTE:

Bonded rubber bushings have a limited range of rotation. Only tighten the threaded connections for the suspension when the vehicle is in curb weight position.

-- Lift the wheel bearing in curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .