Wheel Bearing Housing, Removing And Installing: Removing
FWD
-- Disconnect the connector -1- for the rear speed sensor.
Ignore item -2-.
AWD
-- Loosen the connection between the drive axle and wheel hub. Refer to DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .
-- Disconnect the connector -1- for the rear speed sensor.
Ignore item -2-.
Continuation for All Versions
-- Remove the brake shield. Refer to BRAKE SHIELD, REMOVING AND INSTALLING .
-- Remove the bolt -arrow- and move the bracket -1- to the side together with the wires.
-- Turn the wheel hub, until a wheel bolt hole is at the top.
-- Install the :T10149 with a wheel bolt -2- on the wheel hub.
Ignore item -1-.
-- Slightly lift the wheel bearing housing using the :T10149 with the :VAS6931 this allows the threaded connections to easily separate.
Risk of accident!
- Do not lift or lower the vehicle when the :VAS6931 is under the vehicle.
- Do not leave the :VAS6931 under the vehicle any longer than necessary.
-- Remove the bolts -1 and 2-.
-- Remove the bolts -3 and 4- and disconnect the connector -1-.
-- Loosen the wheel bearing housing -2- from the drive axle and remove it.