Adjusting Shims Available for "S 1 "
| Shim thickness (mm) | ||||
|---|---|---|---|---|
| 0.65 | 0.89 | 1.13 | 1.37 | 1.61 |
| 0.69 | 0.93 | 1.17 | 1.41 | 1.65 |
| 0.73 | 0.97 | 1.21 | 1.45 | 1.69 |
| 0.77 | 1.01 | 1.25 | 1.49 | 1.73 |
| 0.81 | 1.05 | 1.29 | 1.53 | 1.77 |
| 0.85 | 1.09 | 1.33 | 1.57 | |
Tolerance variations make it possible to find the exact shim thickness required.
-- Remove the old shims "S 1 *" and "S 2 *" and install the newly determined shims. Refer to OVERVIEW - DIFFERENTIAL .
Measurement check
-- Turn the differential five turns in both directions after installing the shims "S 1 " and "S 2 " so that the tapered roller bearings can settle.
-- Measure backlash on the circumference four times.
- Specified value: 0.15 ± 4 mm
- Dial Indicator: VAS 6080A
- Dial Gauge Extension (8 cm plan)
- Measuring Lever: VW388
- Ring Gear Locking Sleeve: VW521/4
- Positioning Tolerance Shell: VW521/13
- Dial Indicator Holder: VW 387
- If the torsional backlash is outside of the tolerance, then repeat the adjustment. Total shim thickness "S total " may not be changed.
Tightening Specifications