Tightening the VANOS central valve of the intake adjuster
- To tighten VANOS central valve (1), use reversible ratchet (2) from special tool 0 496 855
with special tool 2 450 487
.
- Tighten the VANOS central valve (1) of the intake adjuster.TIGHTENING TORQUES SPECIFICATION
VANOS central valve to camshaft M21
VANOS central valve on the thread and on the contact surface must be coated with engine oil.1. Joining torque 50 Nm 2. tightening torque 140 Nm M22
VANOS central valve on the thread and on the contact surface must be coated with engine oil.1. Joining torque 50 Nm 2. tightening torque 140 Nm
Follow-up work
- Refer to DISASSEMBLING ALL SPECIAL TOOLS
- Refer to INSTALL CHAIN TENSIONER .
- Refer to CHECKING THE TIMINGS OF THE CAMSHAFT
- Refer to INSTALLING THE HOLDER FOR THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
- Refer to INSTALLING THE THERMOSTAT ON THE TRANSMISSION OIL LINES .
- Refer to INSTALLING CYLINDER HEAD COVER .
- Refer to INSTALLING BOTH ACTUATORS .
- Refer to INSTALLING THE HEAT SHIELD ON THE CYLINDER HEAD
- Refer to INSTALL THE HOLDER OF THE POSITIVE BATTERY CABLE
- Refer to PREPARE THE INJECTORS FOR INSTALLATION .
- Refer to INSTALLING THE RAIL WITH INJECTORS .
- Refer to INSTALLING HIGH PRESSURE PUMP .
- Refer to INSTALLING THE HIGH-PRESSURE LINE BETWEEN THE HIGH-PRESSURE PUMP AND THE HIGH-PRESSURE RAIL .
- Refer to INSTALLING FUEL DELIVERY LINE .
- Refer to INSTALLING ALL SPARK PLUGS .
- Refer to INSTALL ALL IGNITION COILS .
- Refer to INSTALLING CYLINDER HEAD COVER .
- Refer to INSTALL THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALL CHARGE AIR LINE .
- Refer to INSTALL RESONATOR .
- Refer to INSTALLING CENTER BULKHEAD LOWER PART
- Refer to INSTALLING LEFT SEALING FRAME .
- Refer to INSTALLING ACOUSTIC COVER AT REAR
- Refer to FASTENING HIGH-VOLTAGE CABLES ON THE ELECTRICAL MACHINE ELECTRONICS .
- Refer to INSTALLING THE CENTER COWL UPPER PART
- Refer to INSTALL TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALL LEFT AND RIGHT WIPER ARM .
- Refer to INSTALL THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALL THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .
- Refer to CHECK ENGINE OIL LEVEL .
- Refer to CHECKING/TOPPING UP THE OIL LEVEL IN THE AUTOMATIC TRANSMISSION .
- Refer to INSTALLING THE REAR THRUST FIELD .
- Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALL REAR UNDERBODY PROTECTION .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALL THE FRONT HOOD SEAL AT THE REAR .
- Refer to TAKE HOOD OUT OF THE SERVICE POSITION .