Install/replace the left rail pressure sensor

Prerequisite 

Rail removed

• Screw in and tighten the rail pressure sensor (2) into the rail.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Rail pressure sensor to rail
  Rail pressure sensor M10	Tightening sequence	35 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Unclamp the rail on the lug (1).

Follow-up work 

• Refer to INSTALL THE HIGH-PRESSURE RAIL ON THE LEFT .
• Refer to INSTALL THE IGNITION COILS OF CYLINDER BANK 2 .
• Refer to INSTALLING COOLANT EXPANSION TANK .
• Refer to INSTALLING THE CONTROL UNIT BRACKET FOR CYLINDERS 5 TO 8 .
• Refer to INSTALL CLEAN AIR PIPE, TOP .
• Refer to INSTALLING THE COVER OF THE LEFT DME CONTROL UNIT .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .