Installing the support for the lower front bumper panel
NOTE:
Description is for right component only.
The procedure on the left side is identical.
The procedure on the left side is identical.
- Feed in support for the bumper panel at front bottom (3).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Bottom support on front axle support adapter | ||
| M8x75 screw | Tightening torque | 19 Nm |
- Install the expanding rivet (1).
NOTE:
Description is for right component only.
The procedure on the left side is identical.
The procedure on the left side is identical.
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Support on vertical connection | ||
| M6x20 screw | Tightening torque | 11.8 Nm |
- Tighten the screws (1).
TIGHTENING TORQUES SPECIFICATION
| Sensor bracket/ACC sensor | ||
| Screw | Tightening torque | 8 Nm |
Follow-up Work
- Install front BUMPER PANEL .
- Install front underbody protection and/or front STIFFENING PLATE .
- Install front GRILLE .
- Install the left and right top engine compartment COVER
- Install (partially removed) front section of front wheel ARCH COVER