Installing the module carrier on the rear door

Check gasket (1) of the module carrier (2) for damage.
If the seal (1) is damaged, replace the module carrier (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in module carrier completely with the power window and close the snap fasteners (2).
Attach wiring harness (1) and connect the plug connections.

Courtesy of BMW OF NORTH AMERICA, INC.
Tighten the screws (1).

TIGHTENING TORQUES SPECIFICATION

Module carrier to door
Screw	Tightening torque	8 Nm

Move the power window upwards until the fixed side window glass correctly engages in the holder.
Remove adhesive tape.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work