Installing the steering shaft seal
- Position the steering shaft seal (1).
Tighten the nuts (arrows).
TIGHTENING TORQUES SPECIFICATIONBearing plate to firewall M6 Tightening torque 8 Nm - If installed:
Position the cover of the steering shaft seal (3).
Tighten down screw (1).
Tighten nut (2).
TIGHTENING TORQUES SPECIFICATIONCowl panel to firewall Screw Tightening torque 3 Nm Sheet metal nut Tightening torque 2.5 Nm
Follow-up work
- Install the INTEGRATED POWER SUPPLY MODULE (PDM).
- Install the DME CONTROL UNIT .
- Install control unit BRACKET .
- Install acoustic COVER .
- ACTIVATE high-voltage system.
- Check the steering wheel STRAIGHT-AHEAD DRIVING POSITION .
- CHECK the airbag for function.

