Remove the rear spring strut (EDC)
WARNING:
Pyrotechnic components.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- All work on pyrotechnic parts may be carried out by technically experienced and appropriately trained personnel only.
- Replace any damaged part or ones that have been dropped.
- For additional information see: 72 00 SAFETY REGULATIONS on handling components with gas generators.
Preliminary work
- Deactivate the 48 v ELECTRICAL SYSTEM .
- Disconnect all BATTERY GROUND LEADS .
- Remove rear left or right WHEEL .
- Remove rear wheel arch COVER .
- Disconnect the dynamic damping control PLUG CONNECTIONS .
- Remove the camber control arm COVER .
- Remove the storage shelf TRIM PANEL .
- Remove rear upper SEAT BELT .
- Set the SOUNDPROOFING MAT aside.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Loosen nuts (1).
- Secure spring strut against falling out.
- Loosen screw (1).
- Remove spring strut (1).
