Procedure for track and camber adjustment in design position
| A | Track | 1 | Actual value |
| B | Camber | 2 | Intermediate adjustment value |
| C | Track/camber adjustment at wishbone | 3 | Setpoint value in KO position |
| D | Track/camber adjustment at camber control arm |
Description using example value entered in diagram
- Read off actual value (1) for track/camber on axle alignment and enter in diagram (in example: track-10', camber-90')
- Draw parallel line to "wishbone" line (C) through entered actual value (1)
- Intersection point (2) on "camber control arm" line (D) gives intermediate track/camber adjustment value (in example: track - 2', camber - 98')
- Set intermediate adjustment value (2) by turning adjustment screw of wishbone.
- Set setpoint value (3) for track/camber by turning adjustment screw on camber control arm (track/camber value shifts on line (D))