Installing the anti-roll bar
If installed: Installing the anti-roll bar
- Position the anti-roll bar (2).
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | |
| M12 Replace screws. |
Joining torque 100 Nm Angle of rotation 45° |
If installed: Install the active stabilizer in front
- Position active stabilizer on front axle support.
- Replace screws (1).
Parts: Screws
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar to front axle support | |
| M12 Replace screws. |
Joining torque 100 Nm Angle of rotation 45° |
- Position wiring harness on holder.
- Tighten the bolt (1) with the ground strap on the holder and wiring harness.
TIGHTENING TORQUES SPECIFICATION
| Front active stabilizer cable with ground strap to holder | |
| tightening torque 8 Nm |
|
- Position the holder of the connector for the active stabilizer on the front axle support.
- Tighten down screw (1).
TIGHTENING TORQUES SPECIFICATION
| Active stabilizer connector bracket to front axle support | |
| tightening torque 8 Nm |
|
- Connect plug connections (1) and (2).
Securing the anti-roll bar link on the left and right to the anti-roll bar
NOTE:
Perform the steps on the right and left side.
Securing the anti-roll bar link to the anti-roll bar
- Position the anti-roll bar link (3) on the anti-roll bar (2).
- Replace nut (1).
Parts: Nut
- Tighten nut (1).
NOTE:
Counter-hold at the Torx socket.
TIGHTENING TORQUES SPECIFICATION
| Anti-roll bar link to anti-roll bar | |
| M12 Replace nut. |
tightening torque 100 Nm |
