Removing the ignition coils of cylinders 1 and 5

Prerequisite

Ignition is switched off.

NOTE: RISK OF DAMAGE
Damage to the ignition coil.
The silicone hose of the ignition coil must not be contaminated by fuel as this can lead to failure of the ignition coil.

When working on the fuel system, cover the ignition coils with suitable materials and remove where required.
Do not oil or grease the silicone tube of the spark plug socket. Do not use any protection or maintenance products (e.g. silicone spray, rubber care products, rust remover, etc.).

NOTE: The description is for one component only. The procedure is identical for all further components.

Release the clamps (arrows).
Remove cable (1) and put to one side.
Guide out and remove the cover (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (arrow) and disconnect.
Loosen screws (1).
Remove the cable clip (2) and put to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen screws (1).
Slowly pull the ignition coil (2) up and take out without jerking it.
Pulling out the ignition coil with jerks may cause silicone hose to tear.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen clamps (1).
Thread cable (2) out of holders (arrows) and place to one side.

Courtesy of BMW OF NORTH AMERICA, INC.
Unlock plug connection (arrow) and disconnect.
Loosen nut (1).
Loosen screw (2).
Remove the cable clip (3) and put to one side.

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screw (1).
Slowly pull the ignition coil (2) up and take out without jerking it.

Pulling out the ignition coil with jerks may cause silicone hose to tear.

Courtesy of BMW OF NORTH AMERICA, INC.