Installing right high pressure pump

NOTE: RISK OF DAMAGE
Contaminant or foreign body.
Contamination can result in malfunctions, loss of function or leaks.

Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.

NOTE: TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

NOTE: TECHNICAL INFORMATION
Only N63:
On vehicles with an active stabilizer (ARS), the fan cowl must be removed to crank the engine.
For additional information see: 17 11 035 REMOVING AND INSTALLING/REPLACING FAN COWL WITH ELECTRIC FAN .

Remove the seal (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Check the threads (1) on the high pressure pump flange for sealing compound residue: Remove sealing compound residue as needed.
Clean the thread (1).
Make sure that no contamination enters the engine.
Cover opening at the high pressure pump flange with suitable materials.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The sealing surfaces must be free of oil, grease and cleaning agents.

Clean sealing surface (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Replace the high-pressure pump seal (1).
Parts: Gasket
Remove residual screw sealant in the threaded holes on the high pressure pump bracket using compressed air.

Courtesy of BMW OF NORTH AMERICA, INC.

Insert and install the gasket (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Place the depth gauge (1) flat onto the high pressure pump flange.
Turn the engine at the central bolt in the direction of the engine rotation until the depth gauge shows that the camshaft has reached the BDC position.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: RISK OF DAMAGE
Damage to the engine.
If the engine is manually rotated in the wrong direction of rotation, the engine can be damaged.

Only rotate the engine manually in the correct direction of rotation: a) clockwise when looking at the damper, or b) counterclockwise when looking at the chain drive. b) applies only if the timing chain is installed in the rear.

Rotate the engine with the special tool in the direction of the arrow until the cam of the high-pressure pump drive is at the BDC position.

Courtesy of BMW OF NORTH AMERICA, INC.
Coat piston rest (1) of the high pressure pump (2) with engine oil.

Engine oil

Technically suitable engine oils for BMW Group engines

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The high pressure pump is preloaded by the piston spring and must be removed by alternately unscrewing the screws without tilting.
Before installing the high pressure pump, the cam of the high pressure pump drive must be turned to bottom dead center.
If necessary, turn the engine in the direction of engine rotation on the central bolt of the crankshaft, otherwise there is a risk of piston breakage of the high pressure pump.

Courtesy of BMW OF NORTH AMERICA, INC.

Turn the high pressure pump (1) clockwise and position it.
Feed in and install high pressure pump (2).
Replace screws (1).

Parts: Screws

Position the screws (1) on the high pressure pump (2) and tighten in alternating order in steps of 90° each.

Compliance with this specification is imperative to make sure that the piston will not break due to twisting.

TIGHTENING TORQUES SPECIFICATION

High-pressure pump to cylinder head
M6 Replace screws.	Tightening torque 11.8 Nm Angle of rotation 90°

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten nut (1).

TIGHTENING TORQUES SPECIFICATION

Fuel delivery line to high pressure pump
M14	Tightening torque 30 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Connect plug connection (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.