Reset ultra-small quantity adaptation
NOTE:
TECHNICAL INFORMATION
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
If the DME control unit or an injector is replaced, minimum quantity adaptation must be reset. If an injector has been replaced on cylinder side, the minimum quantity adaptation must also be reset.
- Connect the diagnostic system to reset the minimum quantity adaptation:
- Read out vehicle data
- Identification without vehicle test
- Start vehicle test
- Vehicle handling
- Service functions
- Drive
- Engine electronics
- Adjustment programs
- Delete adaptations
- Reset adaptation values
- Reset ultra-small quantity adaptation