Install all ignition coils
NOTE:
The description is for one component only. The procedure is identical for all further components.
Install ignition coil
- Install ignition coil (3).
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Ignition coil screw Tightening torque
8 Nm - Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Connect the connector (1) with the holder (2) and lock (arrow).
The connector (1) must engage audibly.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
NOTE:
The description is for one component only. The procedure is identical for all further components.
Install ignition coil
- Install ignition coil (3).
- Tighten down screw (2).TIGHTENING TORQUES SPECIFICATION
Ignition coil screw Tightening torque
8 Nm - Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Mount the connector (1) of the Lambda oxygen sensor and the oxygen sensor monitor on the cable duct (2).
