If installed: Install the torsion strut on the right, and on the left where required
Install right torsion strut
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Thread in torsion strut (2) and install.
- Replace screws (1).
Parts: screw
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Torsion strut to mounting M12
Replace screws.Tightening torque
100 Nm
Angle of rotation
90°NOTE: Description is for left component only. Procedure on the right side is identical. - Thread in the tank cover (1) and install.
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Undershield | |
| screw | Tightening torque 2.6 Nm |
| Plastic nut | Tightening torque 2.6 Nm |
For dual-flow exhaust system: Install the left torsion strut
- Thread in torsion strut (2) and install.
- Replace screws (1).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Torsion strut to mounting M12
Replace screws.Tightening torque
100 Nm
Angle of rotation
90° - Thread in the tank cover (1) and install.
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Undershield | |
| screw | Tightening torque 2.6 Nm |
| Plastic nut | Tightening torque 2.6 Nm |
Install right torsion strut
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Thread in torsion strut (2) and install.
- Replace screws (1).
Parts: screw
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Torsion strut to mounting M12
Replace screws.Tightening torque
100 Nm
Angle of rotation
90°NOTE: Description is for left component only. Procedure on the right side is identical. - Thread in the tank cover (1) and install.
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Undershield | |
| screw | Tightening torque 2.6 Nm |
| Plastic nut | Tightening torque 2.6 Nm |
For dual-flow exhaust system: Install the left torsion strut
- Thread in torsion strut (2) and install.
- Replace screws (1).
Parts: screw
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Torsion strut to mounting M12
Replace screws.Tightening torque
100 Nm
Angle of rotation
90° - Thread in the tank cover (1) and install.
- Tighten screws (arrows).
TIGHTENING TORQUES SPECIFICATION
| Undershield | |
| screw | Tightening torque 2.6 Nm |
| Plastic nut | Tightening torque 2.6 Nm |

