Install charge air line

• Replace the sealing ring (1) on the throttle valve.

  Parts:  Sealing ring

  Courtesy of BMW OF NORTH AMERICA, INC.

• Check the sealing ring (1) on the charge air line for damage and replace, if necessary.

Courtesy of BMW OF NORTH AMERICA, INC.

Replacing the damaged seal 

• Remove damaged seal.
• Clean the gasket groove (1) with a dry cloth.

  The gasket groove (1) must be clean.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace gasket.

  Parts:  Gasket

• Install the seal dry without lubricant or mounting agent.
  NOTE: TECHNICAL INFORMATION 
  Incorrect assembly is possible. Ensure correct installation position.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Thread in seal and install.
• Make sure that the seal is installed correctly in the gasket groove (1).
• Make sure that the sealing lip (2) is directed to the inside as shown.

• Insert and install charge air line (5).
• Lock the clamp (4) on the exhaust turbocharger.

  Clamp (4) must engage audibly.

• Tighten screws (arrows).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Charge air line to throttle body
  M6	tightening torque  8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect and lock connector (3) on the charge-air temperature sensor.
• Connect and lock connector (1) on the boost pressure sensor.

  All connectors must audibly engage.

• Secure clamps (2).