Moving the engine to the installation position
Install the engine bridge
Prepared engine bridge
CAUTION:
Components connected to the engine joint or cross member.
Injury hazard!
Injury hazard!
- Check lifting eyes and engine mounting brackets for damage, e.g. cracks.
- Attach the component to correctly mounted engine joints or cross members only.
- Only lift the component, do not shift it forwards, backwards or in transverse direction.
NOTE:
Perform the steps on the right and left side.
- Loosen the rivet (1).
- Remove the lateral hood seal (2) from the shock tower.
- Release the screws (1) left and right.
- Carefully position engine bridge (1) with help from an assistant.
- Make sure that the special tool 0 496 438 (00 6 053) from the set of special tools 0 496 430 (00 6 050) , left, rests correctly on the lock support.
- Make sure that special tool 0 496 437 (00 6 052)
from the set of special tools 0 496 430 (00 6 050),
left, rests correctly on the shock tower.
- Make sure that the special tool 0 496 438 (00 6 053) from the set of special tools 0 496 430 (00 6 050) , right, rests correctly on the lock support.
- Make sure that special tool 0 496 437 (00 6 052)
from the set of special tools 0 496 430 (00 6 050),
right, rests correctly on the shock tower.
- By shifting the engine bridge on the profile strips of the special tool 0 496 430 (00 6 050), align it above the engine mounting bracket (1) and screw in place.
- Align hook 0 496 733 (00 6 080) above engine mounting bracket (1).
- Connect hook 0 496 733 (00 6 080)
to engine mounting bracket (1).
Detach the engine mounting bracket from the left and right engine mounts
NOTE: Description is for left component only. Procedure on the right side is identical.Detach the engine mounting bracket from the engine mount
- Loosen screw (1).
- Lift the engine by 10 mm by turning the spindle 2 361 506 (00 6103).
