Start-up or bedding in break-in of new brake pads and blades (rear brake)
NOTE:
TECHNICAL INFORMATION
When exchanging brake pads, reset the CBS display in accordance with factory specification (CBS reset).
Carry out test braking while driving at low speed because the effectiveness of the brakes may be reduced during the brake slowly operations.
Exaggerated emergency and continuous braking operations for faster bedding in break-in are not permitted.
Advise the customer not to perform intentional emergency braking operations for the first 200 km after the brakes have been replaced.
When exchanging brake pads, reset the CBS display in accordance with factory specification (CBS reset).
Carry out test braking while driving at low speed because the effectiveness of the brakes may be reduced during the brake slowly operations.
Exaggerated emergency and continuous braking operations for faster bedding in break-in are not permitted.
Advise the customer not to perform intentional emergency braking operations for the first 200 km after the brakes have been replaced.
- Fully depress brake pedal several times so that brake pads contact brake discs.
- Switch the ignition on.
Use the parking brake button to open, close and open the parking brake again.
- Switch off ignition.
- Adjust the brake fluid level to the maximum mark.
- Perform a functional check on the brake test stand to ensure compliance of the brake system with statutory guidelines.
- Attach interior mirror tag to inside mirror.