Take engine out of installation orientation

Lower the engine by turning the spindle 2 361 506 (00 6 103) until the engine is completely in contact with the engine mounts.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed out the hook (1) and set it aside.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
Conduct the following operation with the assistance of a second person.
Remove the engine bridge (1) with the help from another person.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screws (1) on the left and right.

TIGHTENING TORQUES SPECIFICATION

Top rear connection to body
Torx screw M8x30	tightening torque	19 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen the screws (1) from the special tool 2 459 012
Guide out and remove the special tool 2 459 012 on the cylinder head.

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1) on right engine support bracket from the top.

TIGHTENING TORQUES SPECIFICATION

Engine mount to engine support bracket
M12	tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Tighten screw (1) on left engine support bracket from the bottom.

TIGHTENING TORQUES SPECIFICATION

Engine mount to engine support bracket
M12	tightening torque	100 Nm

Courtesy of BMW OF NORTH AMERICA, INC.