Installing the camber control arm
- Swivel the camber link (1) upward in the arrow direction.
- Replace the eccentric screw (4), the eccentric washer and the nut (5).
Parts: eccentric screw, eccentric washer, nut
- Insert the eccentric screw (4).
- Connect eccentric washer.
- Screw on the nut (5).
- Replace screw (2) and nut (3).
Parts: Bolt, nut
- Insert the screw (2).
- Screw on the nut (3).NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION . - Tighten nut (3) in NORMAL POSITION .TIGHTENING TORQUES SPECIFICATION
Anti-roll bar link to camber control arm M10
Replace screw and nut.
Tighten in NORMAL POSITION .Joining torque 56 Nm Angle of rotation 90° - Tighten nut (5) in the NORMAL POSITION .TIGHTENING TORQUES SPECIFICATION
Camber control arm to rear axle support M14
Replace bolt, nut and eccentric washer.
Tighten in NORMAL POSITION .tightening torque 175 Nm
