Installing the catalytic converter for cylinders 5 to 8
- Replace seals on exhaust turbocharger.
Parts: Seals
- Guide in and install the catalytic converter (1) for cylinders 5 to 8 in the arrow direction.
- Connect the catalytic converter (1) for cylinders 5 to 8 to the exhaust turbocharger.
- Guide in and install the catalytic converter (1) for cylinders 1 to 4 in the arrow direction.
- Connect the catalytic converter (1) for cylinders 1 to 4 to the exhaust gas turbocharger.
- Replace clamps (1) and (2).
Parts: Clamps
- Mount clamps (1) and (2) and tighten.
The circlips (1) and (2) must be mounted with the screw connection to the inside.
TIGHTENING TORQUES SPECIFICATIONCatalytic converter to exhaust turbocharger cl
Replace clamp after disassembly.Tightening torque 14 Nm - Install holder (4).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Catalytic converter on cylinder head/cylinder head cover/holder M8x20 tightening torque 21 Nm - Tighten down screws (2).TIGHTENING TORQUES SPECIFICATION
Catalytic converter on cylinder head/cylinder head cover/holder M8x20 tightening torque 21 Nm - Tighten down screw (3).TIGHTENING TORQUES SPECIFICATION
Catalytic converter on cylinder head/cylinder head cover/holder M8x20 tightening torque 21 Nm - Install holder (4).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Catalytic converter on cylinder head/cylinder head cover/holder M8x20 tightening torque 21 Nm - Tighten down screws (2).TIGHTENING TORQUES SPECIFICATION
Catalytic converter on cylinder head/cylinder head cover/holder M8x20 tightening torque 21 Nm - Tighten down screw (3).TIGHTENING TORQUES SPECIFICATION
Catalytic converter on cylinder head/cylinder head cover/holder M8x20 tightening torque 21 Nm For equipment specification without SA1 DC gasoline particulate filter
WARNING: Hot exhaust system.
Risk of burning!- Any work must exclusively be carried out with an exhaust system that has cooled down.
- Mount catalytic converter for cylinders 1 to 4 on holder.
- Replace screws (1).
Parts: screw
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Catalytic converter to holder M8x20
Replace screw.tightening torque 19 Nm - Mount catalytic converter for cylinders 5 to 8 on holder.
- Replace nuts (1).
Parts: Nuts
- Tighten nuts (1).TIGHTENING TORQUES SPECIFICATION
Catalytic converter to holder M8 Nut
Replace nut.tightening torque 23 Nm
