Install the cylinder head cover (engine removed)

Replace the profile seal (1).
Parts: Profile seal

Courtesy of BMW OF NORTH AMERICA, INC.
Make sure that the cylinder head cover (1) is correctly fitted on the high pressure pump bracket (2) in the marked area.
Make sure that the cylinder head cover (1) does not rest on the high pressure pump bracket (2) in the marked area.

Courtesy of BMW OF NORTH AMERICA, INC.
Fit cylinder head cover.
Make sure that the cylinder head cover does not rest on the high pressure pump bracket!
Join all the screws of the cylinder head cover in the sequence (1) to (15) in 180° increments.
Tighten the screws of the cylinder head cover in the sequence (1) to (15).

TIGHTENING TORQUE SPECIFICATIONS

Cylinder head cover to cylinder head
M6	Tightening torque	8 Nm
	Tightening torque	11 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

Fuel delivery line to cylinder head cover
	Tightening torque	6.5 Nm

Position the engine wiring harness (3) and clip in the marked area.
Clip in the cable in the marked areas.
Position the carrier plate and secure it with the bolt (2).
Clip in both oxygen sensor connectors (1) on the carrier plate.

Courtesy of BMW OF NORTH AMERICA, INC.
Correctly route the engine wiring harness (3) and clip in the highlighted area.
Clip in the engine ventilation line (2).
Connect and lock both connectors (1).

Courtesy of BMW OF NORTH AMERICA, INC.