Mounting seal on the front door
NOTE:
TECHNICAL INFORMATION
The repair instructions of bonded seals form the basis for these repair instructions and must be observed without fail.
For more information see: 54 10... REPAIR INSTRUCTIONS for bonded seals
The repair instructions of bonded seals form the basis for these repair instructions and must be observed without fail.
For more information see: 54 10... REPAIR INSTRUCTIONS for bonded seals
- Hang the seal (1) over the door with the open lip facing inwards.
- Sealing joint in area (A) position.
- Glue seal as follows:
- Gradually pull off protective film
- Align seal (1) corresponding to the specified dimensions (X) or the templates and press on lightly
- Check the position of the sealing (1) and correct if necessary
- Do not overstretch or compress the sealing (1) when positioning it
- Maximum permissible sag of the seal (1) during the positioning process is 30 mm
- Always apply pressure perpendicular to the bonding surface to affix the sealing (1)
- Affix sealing (1) with firm thumb pressure
Area Dimension x A 13 mm B 6.5 mm C 4 mm D 5 mm - Create a sealing joint in area (A), and shorten the seal (1) accordingly as needed.
- Position the seal (1) along the template (3):
The edge of the seal (1) is flush with the mark (4) (arrow) of the template (3).
- Sealing
- Adhesive tape of seal
- Template
- Mark for the seal
Follow-up Work
- Install the inside window frame COVER .
- Install front inner WEATHER STRIP .
- Install front door TRIM PANEL .
- Install the mirror triangle COVER .
- Attach the door handle COVER .