Attaching the engine on the workshop crane
CAUTION:
Materials harmful to health.
Contact with fluids harmful to health!
Contact with fluids harmful to health!
- Note and follow safety instructions on containers.
- Conduct all work in appropriate personal protective equipment only.
NOTE:
RISK OF DAMAGE
Damage to the engine block.
Serious damage to the engine block and transmission due to damaged and corroded screws.
Damage to the engine block.
Serious damage to the engine block and transmission due to damaged and corroded screws.
- It is imperative that protruding threads of the transmission bolts are checked for corrosion and damage prior to removal.
- It is imperative that all rust is removed from corroded threads and that they are cleaned prior to removal.
- Replace rusted and damaged bolts.
NOTE:
RISK OF DAMAGE
Damage to the transmission.
Damage to the transmission due to unapproved transmission oil.
Damage to the transmission.
Damage to the transmission due to unapproved transmission oil.
- Use only the approved transmission oil.
- Check the transmission oil level after completing the repair.
Preliminary work:
- Refer to UNCLIPPING THE COOLANT LINE FROM THE FRONT AXLE SUPPORT .
- Refer to REMOVING THE FRONT OUTPUT SHAFTS (ON THE MOBILE LIFTING TABLE) .
- Refer to REMOVING STARTER MOTOR
- Refer to REMOVING EXHAUST SYSTEM HOLDER .
- Refer to DISCONNECTING HYDRAULIC LINES ON THE TRANSMISSION .
- Refer to DISCONNECTING THE CONNECTOR FROM THE SEALING SLEEVE .
- Refer to TURNING THE ENGINE HAND FORCE .
- Refer to RELEASING CONVERTER BOLT .
- Refer to SECURING THE TORQUE CONVERTER .
- Refer to UNDO REMAINING TORX SCREWS .
- Refer to UNDOING ENGINE FROM AUTOMATIC TRANSMISSION (ON MOBILE TABLE LIFT) .
- Refer to REMOVING THE PROP SHAFT FRONT AT THE FRONT AXLE TRANSMISSION .
- Refer to RELEASING THE ENGINE SUPPORT BRACKETS ON THE LEFT AND RIGHT ENGINE MOUNTS .
CAUTION:
Components connected to the engine joint or cross member.
Injury hazard!
Injury hazard!
- Check lifting eyes and engine mounting brackets for damage, e.g. cracks.
- Attach the component to correctly mounted engine joints or cross members only.
- Only lift the component, do not shift it forwards, backwards or in transverse direction.
- Stage the workshop crane 2 220 718.
- Stage the lifting gear 0 490 567 (11 0 020). NOTE: TECHNICAL INFORMATION
The workshop crane, lifting gear and the mounting brackets on the engine must all be connected to each other so that the engine hangs straight upon lifting. - Connect both hooks of the special tool 0 490 567 (11 0 020) to the front and rear of the engine with the mounting brackets.
- Connect the workshop crane 2 220 718
to the special tool 0 490 567 (11 0 020).
- Raise and remove the engine.
