Install front engine encapsulation

• Check the engine encapsulation (1) for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Carefully pull the engine wiring harness (1) forward.
• Insert the engine encapsulation (2) from the top.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the connector (3) with the heat management module.
• Connect the connector (2) to the heating element.
• Connect the connector (1) to the exhaust turbocharger.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the engine encapsulation with the expanding rivet (2).
• Connect connector (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the engine wiring harness (1) in the highlighted areas,

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the O-ring for the oil feed line.

  Parts:  O-ring

• Position oil feed line (2).
• Tighten down screw (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Oil feed line on cylinder head
  M6x12 Replace O-ring.	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Refer to INSTALLING AUXILIARY COOLANT PUMP FOR THE EXHAUST TURBOCHARGER .
• Refer to INSTALL THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
• Refer to CONNECT THE COOLANT LINE OF HIGH-TEMPERATURE COOLANT CIRCUIT
• Refer to FILL THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
• Refer to INSTALL CHARGE AIR LINE .
• Refer to INSTALLING CLEAN AIR PIPE .
• Refer to INSTALL RESONATOR .
• Refer to INSTALL ACOUSTIC COVER .
• Refer to BLEED THE HIGH-TEMPERATURE COOLANT CIRCUIT .
• Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT STIFFENING PLATE .
• Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .