Installing the knock sensors for cylinders 1 to 2
NOTE:
TECHNICAL INFORMATION
When installing the knock sensors, the tightening torque must be observed.
Non-compliance with the tightening torque can lead to malfunction.
When installing the knock sensors, the tightening torque must be observed.
Non-compliance with the tightening torque can lead to malfunction.
- Clean the contact surface of the knock sensor at the crankcase.
- Install knock sensor (3).
- Tighten down screw (2).
TIGHTENING TORQUES SPECIFICATION
| Knock sensor to crankcase | ||
|---|---|---|
| M8x30 Observe tightening torque without fail! | tightening torque | 21.5 Nm |
Follow-up work
- Refer to INSTALLING THE ALTERNATOR .
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING RESONATOR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING NEGATIVE BATTERY CABLE .