Installing the auxiliary coolant pump for the exhaust turbocharger
NOTE:
RISK OF DAMAGE
Non-visible damage to the coolant pump.
Forcibly removing, installing or dropping the coolant pump down will damage it.
Non-visible damage to the coolant pump.
Forcibly removing, installing or dropping the coolant pump down will damage it.
- Remove and install the coolant pump without damaging it and without applying external force.
- Avoid impacts/knocks to the coolant pump (e.g. by tools, falling down, hard contact with base).
- Replace coolant pump after being dropped or hard impacts/knocks.
NOTE:
TECHNICAL INFORMATION
Make sure that the connections are locked correctly. The locks must engage audibly.
Make sure that the connections are locked correctly. The locks must engage audibly.
- Feed in and position auxiliary coolant pump.
- Feed in and install retainer (4) in the marked area.
- Tighten nut (3).
TIGHTENING TORQUES SPECIFICATION
| Auxiliary coolant pump holder to cylinder head | ||
|---|---|---|
| M6 | tightening torque | 8 Nm |
- Feed in and install coolant line (2).
- Make sure that the coolant line (2) engages audibly.
- Connect connectors (1) and lock.
- Make sure the connector (1) engages audibly.
Follow-up work
- Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATER TIGHTNESS .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
- Refer to INSTALLING RESONATOR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT THRUST FIELD .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .