Install hydraulic unit

• Position hydraulic unit (3).
• Insert screws (2) and tighten.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Hydraulic unit with holder on body
  Replace screws.	Tightening torque	8 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the plug connection (1).
• (1) Fit brake lines and tighten.

  Hold on to square shaft, if necessary (2).

  TIGHTENING TORQUES SPECIFICATION
  
  

  Brake pipe screw connection/Union screws
  	Tightening torque	17 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• (1) Fit brake lines and tighten.

  Hold on to square shaft, if necessary (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Install the sides UNDERSHIELD .
• Install the front wheel arch COVER REAR SECTION .
• Clean the CONTACT SURFACES between the brake disc and the wheel rim.
• Attach the front left WHEEL .
• Remove the brake pedal TENSIONER .
• Connect the brake fluid BLEEDER UNIT .
• FLUSH AND VENT  the rear axle brake circuit.
• FLUSH AND BLEED  the front axle brake circuit (brake high).
• Disconnect the brake fluid BLEEDER UNIT .
• DSC unit start-up/driving dynamics sensor adjustment/control unit PROGRAMING