Install the rear spring strut (EDC)
Further information is available.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Position the spring strut (1) in the wheel arch.
- Position the spring strut on the strut-tower.
- Replace nuts (1).
Parts: Nuts
- Tighten nuts (1).TIGHTENING TORQUES SPECIFICATION
Rear spring strut to body M8
Replace nut.Tightening torque 28 Nm NOTE: TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
For additional information see: 33 00 TECHNICAL DATA Overview - Position the spring strut on the wheel carrier.
- Replace the screw (1).
Parts: Screw
- Tighten screw (1) in normal position.
TIGHTENING TORQUES SPECIFICATION
| Rear spring strut to wheel carrier | ||
| M16 Replace screw. Tighten in NORMAL POSITION . |
Tightening torque | 250 Nm |
Follow-up work
- Position soundproofing MAT .
- Install rear upper SEAT BELT .
- Install the storage shelf TRIM PANEL .
- Install the camber control ARM COVER .
- Connect the dynamic damping CONTROL CONNECTOR .
- Install the rear wheel arch COVER .
- Install rear left or right WHEEL .
- Reconnect all battery GROUND LEADS .
- Activate the 48 v ELECTRICAL SYSTEM .