Securing rear left and right air suspension struts on the wheel carrier
NOTE:
Perform the operations on the left and right side.
Securing rear spring strut shock absorber on the wheel carrier
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the normal position.
For additional information see: 33 00 Overview of TECHNICAL DATA
Tighten the screw connection in the normal position.
For additional information see: 33 00 Overview of TECHNICAL DATA
- Position spring strut shock absorber (1) on the wheel carrier.
- Replace the screw (2)
.
Parts: Screw
- Tighten down bolt (2)
in NORMAL POSITION
.TIGHTENING TORQUES SPECIFICATION
Rear spring strut to wheel carrier M16
Replace screw.
Tighten in normal position.Tightening torque 250 Nm
Follow-up Work
- Secure rear left and right BRAKE CALIPER .
- If installed: fasten CABLE .
- If installed: connect the CABLE .
- Connect the left and right CONNECTOR .
- Secure right and left CABLES .
- Connect the rear ride height sensor CONNECTOR .
- Secure the rear axle differential PROPELLER SHAFT .
- Install the rear HEAT SHIELD .
- If installed: install the torsion struts MOUNTING BLOCK .
- Install EXHAUST SYSTEM .
- Install the left and right camber control arm COVER .
- Install TANK COVER .
- Install the left and right REAR WHEEL .