Install wheel carrier
- Position the wheel carrier (1) on the wishbone.
- Replace the screw (3)
and the nut (2)
.
Parts: Bolt, nut
- Insert screw (3) .
- Tighten nut (2)
.TIGHTENING TORQUES SPECIFICATION
Upper wishbone to wheel carrier M14
Replace screw and nut.Jointing torque 165 Nm Angle of rotation 90°
Follow-up Work
- Install the rear BRAKE DISC
- Fasten the wheel carrier control arm SPRING STRUT .
- Mount the wheel carrier trailing arm camber CONTROL ARM
- Secure the wheel carrier wheel SPEED SENSOR
- Mount the wheel carrier CONTROL LINK
- Secure rear BRAKE CALIPER .
- Secure the wheel bearing OUTPUT SHAFT
- Install rear left or right WHEEL .
- Measure the RIDE HEIGHT of the rear axle and adjusting the NORMAL POSITION .
- Tighten the wheel carrier SCREW CONNECTIONS .
- Perform chassis ALIGNMENT CHECK .
- Install the camber control arm COVER .