Installing the steering gear

NOTE: TECHNICAL INFORMATION
The screws for the steering gear are self-tapping. Therefore, do not cut a thread into the steering gear.

Install the steering gear (2).
Insert the screws (1) by hand force but do not tighten.

Courtesy of BMW OF NORTH AMERICA, INC.

Install the anti-roll bar (3).
Insert the screws (1) and (2) by hand force but do not tighten.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
When assembling, it is essential to observe screwing sequences and tightening torques.
Non-compliance with the regulations can lead to damage.

Tighten the bolts of the steering gear in bolt sequence (1-4).

Fig 1: Steering Gear Bolts Tightening Sequence

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Steering gear to front axle support (all-wheel drive vehicles)
M12 Replace screws.	Joining torque	60 Nm
M12 Replace screws.	Angle of rotation	90°

Tighten the bolts (1) from the anti-roll bar to the front axle support.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUES SPECIFICATION

Holder, stabilizer mounting to front axle
M12 Replace screw.	Joining torque	100 Nm
M12 Replace screw.	Angle of rotation	45°

Clip in wiring harness mounting (3).
Clip in cable duct (2) on front axle support.

Connect the connector (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Attach the steering gear UNIVERSAL JOINT .
Install both TIE ROD ENDS
If installed: fasten the ACTIVE STABILIZER (additional work for ARS).
Install the THRUST FIELD .
Install the UNDERBODY PROTECTION of the steering gear or the front thrust field.
Install the front left and right WHEELS .
Disconnect all battery GROUND LEADS .
ACTIVATE the 48 v electrical system.
Perform CHASSIS ALIGNMENT CHECK .
Replacement: Commission (INITIALIZATION) of the electromechanical steering
CHECK the airbag for function.