Installing the right engine mount holder
- Install the engine support bracket (2).
- Tighten down screws (1).TIGHTENING TORQUES SPECIFICATION
Engine support bracket on the engine M10 Tightening torque 38 Nm
Follow-up work
- Refer to INSTALL THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALL THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to INSTALL RESONATOR .
- Refer to INSTALLING INTAKE SILENCER HOUSING
- Refer to INSTALL THE REAR SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to INSTALL THE FRONT LEFT AND RIGHT WHEELS .
- Refer to RESETTING THE TIRE PRESSURE MONITOR .
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to IF INSTALLED: INSTALL THE TORSION STRUT ON THE RIGHT, AND ON THE LEFT WHERE REQUIRED .
- Refer to INSTALL THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALL THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALL LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE DME CONTROL UNIT (2017-2020) , or INSTALLING THE DME CONTROL UNIT (2021-2022) .
- Refer to INSTALL THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALL THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP
- Refer to TAKE HOOD OUT OF THE SERVICE POSITION .