Install high pressure pump

• Feed in and install high pressure pump (2).
• Replace the bolts (arrows).

  Parts  : screw

• Position the screws (arrows) of the high-pressure pump (2) and tighten alternating  in 90°  steps.

  Compliance with this specification is imperative to make sure that the piston will not break due to twisting.

  TIGHTENING TORQUES SPECIFICATION
  
  

  High pressure pump to cylinder head cover
  M6X25 Replace screws.	Tightening torque	12 Nm

• Connect and lock the connector (1).

  The connector (1) must engage audibly.

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALL THE HIGH-PRESSURE LINE BETWEEN THE HIGH-PRESSURE RAIL AND THE HIGH-PRESSURE PUMP .
• Refer to INSTALLING FUEL DELIVERY LINE .
• Refer to INSTALLING THE IGNITION COILS .
• Refer to INSTALLING ACOUSTIC COVER AT REAR .
• Refer to INSTALL ACOUSTIC COVER .
• Refer to INSTALL THE FRONT HOOD SEAL AT THE REAR .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .