Determine installed variant of the wishbone
NOTE:
TECHNICAL INFORMATION
Perform wheel alignment after installation.
Perform wheel alignment after installation.
Preliminary work
- Refer to REMOVING FRONT RIGHT WHEEL .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to IF INSTALLED: REMOVING THE AUXILIARY BATTERY FOR VEHICLE ELECTRICAL SYSTEM SUPPORT IN THE ENGINE COMPARTMENT .
- Refer to DETACHING THE SPRING STRUT IN FRONT .
- Determine by visual inspection of installed wishbone from available or not available +/- identification, besides the end cover of the ball pivot to shoring variant of the new wishbone.
Wishbones with + or - marking (see illustration) are camber correction arms:
An unmarked wishbone is a standard part.
- Block same variant of wishbone (standard part, under-size or oversize variant) again.
