Removing The Side Panel On The Right
WARNING:
Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly.
Danger! Immobilization period-threatening injuries!
Danger! Immobilization period-threatening injuries!
- Observe safety instructions on raising the vehicle using a vehicle hoist.
- For additional information see: 00 02 001 RAISING THE VEHICLE WITH A VEHICLE LIFT (530I 2017-2022, 530I XDRIVE 2017-2022, 530E PHEV 2018-2022, 530E XDRIVE PHEV 2018-2022, 540I 2017-2022, 540I XDRIVE 2017-2022, M550I XDRIVE 2018-2022) .
Preliminary work
- Refer to REMOVE THE TOP RIGHT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVE THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVE THE LID FOR THE WASHER FLUID RESERVOIR .
- Refer to REMOVING THE MOUNT OF THE HOOD SEAL .
- Refer to REMOVING THE WHEEL .
- Refer to REMOVE THE FRONT RIGHT WHEEL ARCH COVER FRONT SECTION
- Refer to REMOVE REAR SECTION OF THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to PARTIALLY RELEASING THE FRONT RIGHT BUMPER COVER ON THE SIDE PANEL .
- Refer to REMOVE THE TRIM FROM THE SIDE PANEL .
- Refer to REMOVE THE AIR DUCT ON THE INNER SIDE PANEL .
- Refer to REMOVE WASHER FLUID RESERVOIR .
- Mask area (1) on the headlight with a plastic adhesive tape.
- Mask the area (1) of the door with plastic adhesive tape.
- Loosen screws (1).
- Release screws (1) at the door sill trim panel.
- Loosen screw (1).
- Loosen screws (1).
- Open the front door.
- Press onto in the signaled area (arrow) from the top and unclip the retaining lug (2).
- Release the seal (1) at the top.
- Loosen screw (3).
- Loosen screws (1).
- Loosen side panel in the sequence and direction shown with the aid of a second person.
- Pull the side panel in the upper area of the A-pillar outwards (1) in the direction of the arrow.
- Release detents (2) on the holder of the door sill trim panel.
- Pull the bottom side panel in the area of the door sill trim panel in the direction of the arrow to the top (3).
- Release detent (4) on the headlight.
- Pull the side panel in the direction of the arrow to the rear (5) and remove it.








