Installing the head-up display

• Connect the associated connector with the head-up display.
• Guide the Head-Up Display (2) into the support.
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Head-Up Display to support
  M6x25 screw	Tightening torque	13 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work 

• Install instrument PANEL TRIM .
• Install the INSTRUMENT CLUSTER  (KOMBI).
• Install the steering column SWITCH CLUSTER (SZL).
• Install lower section steering COLUMN SHROUD .
• Fit upper section steering COLUMN SHROUD .
• Install the STEERING WHEEL .
• Install the steering wheel or sports steering wheel AIRBAG UNIT .
• Install the M sports steering wheel AIRBAG UNIT .
• Install the left fold-down COMPARTMENT .
• Install the CENTRAL INFORMATION DISPLAY (CID).
• Install the left instrument PANEL FINISHER .
• Install the light OPERATING UNIT .
• Install the left instrument panel SIDE PANEL .
• Install the left and right a-pillar TRIM PANEL .
• Install right a-pillar footwell side TRIM PANEL .
• Install the left a-pillar footwell side TRIM PANEL .
• Install both inner front door sill COVER STRIPS .
• Install the instrument panel MID-RANGE SPEAKERS .
• Install the instrument panel SPEAKER TRIM .
• Install the HEAD UNIT HIGH (HU-H).
• Install radio operating unit and air conditioning CONTROL PANEL .
• Install the right instrument PANEL FINISHER .
• Install the right instrument panel SIDE PANEL .
• Install the center CONSOLE .
• Install the right footwell trim PANEL .
• Install the pedal mechanism TRIM PANEL .
• Install the CUP HOLDER .
• Install the center console TRIM .
• Install front storage compartment TRIM .
• Install the center ARMREST .
• Install the center armrest STORAGE COMPARTMENT .
• Install the rear center console TRIM .
• Install the rear VENTILATION GRILLE .
• Install the rear VENTILATION GRILLE (air conditioning with 4-zone control).
• Install the CONTROL PANEL of the rear passenger compartment air conditioning (integrated automatic heating/air conditioning system with 4-zone control).
• Connect all battery EARTH LEADS .
• ENCODE/PROGRAM control unit(s)
• Activate the 48 v ELECTRICAL SYSTEM .