Installing the front brake discs
NOTE:
TECHNICAL INFORMATION
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
Brake discs must only be replaced in pairs (per axle).
Fit new brake discs only together with new brake pads.
- If an arrow 1 is engraved on the brake disk, it must point in the driving direction!
In this case, the left and right brake discs are different!
- Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
- Mount brake disc (2).
- Position and tighten the screw (1).
- Replace screw.
Parts: Screw
TIGHTENING TORQUES SPECIFICATION
| Brake disc to front wheel hub | ||
| M8 Replace screw. |
Tightening torque | 16 Nm |
Follow-up work
- Mount the front CALIPER CARRIER .
- Grease the BRAKE PADS , brake anchor plate and brake caliper using brake pad paste (17 inch brake).
- Install front BRAKE PADS .
- Install front brake pad WEAR SENSOR (16 inch brake).
- Install the front left and right WHEELS .
- COMMISSION/BEDD IN new brake pads and brake discs.