Following the direction of extraction and the direction of insertion of the rubber mount for the rear axle support

NOTE: DANGER
High-voltage system.
The high-voltage system operates on the basis of hazardous, electrical voltage and high currents. Mortal hazard through electric shock!

All work on the high-voltage system may only be carried out by specially trained and technically experienced personnel.
For additional Information see: 61 00... SAFETY INSTRUCTIONS on handling hybrid cars
For additional Information see: 61 25... NOTES on repair of high-voltage battery unit

Preliminary work

Remove the rear left and right WHEELS .
Remove the tank COVERS .
Remove EXHAUST SYSTEM
If installed: remove the torsion struts MOUNTING BLOCK .
Remove the left and right camber control arm COVER .
Remove the rear HEAT SHIELD .
Release the rear axle differential PROP SHAFT .
Disconnect the rear ride height sensor PLUG CONNECTION .
Detach right and left CABLES .
Disconnect the left and the right PLUG CONNECTIONS .
If installed: release the CABLE .
If installed: release the WIRING HARNESS .
Release rear left and right BRAKE CALIPER .
Prepare the SPECIAL TOOL .
Position the SPECIAL TOOL on the rear axle support.
Release the rear left and right wheel carrier spring strut SHOCK ABSORBER .
Detach REAR AXLE
Remove complete rear AXLE SUPPORT .

WARNING: Car may slip off the vehicle hoist where components are supported.
Danger! Immobilization period-threatening injuries!

Secure the vehicle hoist against lowering and lifting.

WARNING: Car may slip off the vehicle hoist if the weight is distributed unevenly.
Danger! Immobilization period-threatening injuries!

Ensure there is a specific weight compensation on the car.

NOTE: RISK OF DAMAGE
Damage to the rear axle support.
Damage to the rear axle support due to non-compliance with the direction of extraction and the direction of insertion of the rubber mount.

Adherence to the pull-out and pull-in direction is absolutely mandatory.

Follow the direction of extraction and the direction of insertion of the rubber mount and also driving direction (F):

Pull the front rubber mount (1) in and out toward the bottom.

Pull the rear rubber mount (2) in and out toward the top.

Courtesy of BMW OF NORTH AMERICA, INC.