Install the HSR actuator

• Position the HSR actuator under the rear axle support.
• Connect connectors (1) and (2) lock.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Position the HSR actuator with the tappet in the bore on the rear axle support.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace screws (2).

  Parts:  Screws

• Tighten screws (2) on HSR actuator (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  HSR actuator to rear axle support (top)
  M14 Replace screws.	Tightening torque	165 Nm

• Replace screw (3) and nut (4).

  Parts:  Bolt, nut

• Insert the screw (3).
• Tighten nut (4).

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUES SPECIFICATION
  
  

  HSR actuator to rear axle support (bottom)
  M12 Replace screw and nut.	Joining torque	100 Nm
  	Angle of rotation	90°

• Secure wiring harness (1) to the HSR actuator.

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: The following step(s) must be performed if the listed component(s) is/are installed.
  NOTE: Perform the steps on the right and left side.
• Replacement:  Remount heat shield (1) on the new HSR actuator.

Courtesy of BMW OF NORTH AMERICA, INC.

Loosen screws (2).

Remove heat shield (1) and position it on the new HSR actuator.

Tighten the screws (2).

Follow-up work 

• If installed: install the torsion struts MOUNTING BLOCK .
• Install the left and right transverse CONTROL ARM .
• Install EXHAUST SYSTEM
• Install the left and right camber control arm COVER .
• Install left and right rear WHEEL .
• ENCODE the HSR actuator.
• Perform chassis ALIGNMENT CHECK .