Install the intermediate pipe

• Insert and install the intermediate pipe (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the screw (1).

  Parts: screw

• Tighten the bolt (1) on the rear axle support.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Exhaust system to rear axle carrier
  M8x25 Replace screw.	Tightening torque	28 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the intermediate pipe (3) with the help of the gripper clamp (1) and the (2) to the front silencer and rear silencer.
• Center the gripper clamps (1) and (2) tighten.
  TIGHTENING TORQUES SPECIFICATION
  
  

  Clamp with partial replacement of exhaust system
  Clamp	Tightening torque	45 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to IF INSTALLED: INSTALL THE TORSION STRUT ON THE RIGHT, AND ON THE LEFT WHERE REQUIRED .