Installing the hydraulic valve for the oil pressure control

NOTE: RISK OF DAMAGE
Contaminant or foreign body.
Contamination can result in malfunctions, operating failure or leaks.

Adhere to the utmost cleanliness.
Protect components from contamination e.g. by covering.
Close off line connections with seal plugs.

Check the O-ring (1) for damage.
If necessary, replace the hydraulic valve.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed in and install the hydraulic valve (3).
Tighten down screw (2).

TIGHTENING TORQUES SPECIFICATION

Hydraulic valve to crankcase
M6 x 18	Tightening torque	8 Nm

Connect and lock the connector (1).
Make sure the connector (1) engages audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up Work

Refer to INSTALLING THE COMPLETE FULL-FLOW OIL FILTER .
Refer to TIGHTENING THE OIL FILTER CAP .
Refer to TOPPING UP THE ENGINE OIL .
Refer to INSTALLING THE INTAKE PLENUM .
Refer to INSTALLING THE TANK VENT VALVE .
Refer to CONNECTING THE COOLANT LINES FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
Refer to CONNECTING THE COOLANT LINES FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE AT THE FRONT .
Refer to INSTALLING CONTROL UNIT HOLDER .
Refer to INSTALLING THE INTEGRATED SUPPLY MODULE (PDM) .
Refer to INSTALLING THE DME CONTROL UNIT .
Refer to INSTALLING RESONATOR .
Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE .
Refer to CONNECTING ALL BATTERY EARTH LEADS .
Refer to BLEEDING THE HIGH-TEMPERATURE COOLANT CIRCUIT .
Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM .
Refer to CHECKING THE HIGH-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
Refer to CHECKING ENGINE OIL LEVEL .
Refer to INSTALLING THE STIFFENING PLATE .
Refer to INSTALLING THE UNDERBODY PROTECTION OF THE STEERING GEAR OR THE FRONT STIFFENING PLATE .
Refer to INSTALLING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
Refer to INSTALLING UNDERBODY PROTECTION AT REAR .
Refer to INSTALLING ACOUSTIC COVER AT REAR .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE SEAL FOR THE BONNET .
Refer to TAKING BONNET OUT OF THE SERVICE POSITION .