Removing special tool on belt tensioner
CAUTION:
Spring preload.
Injury hazard!
Injury hazard!
- The use of the specified special tool (tool) is mandatory.
- Carry out the described steps properly.
- Twist belt tensioner (1) in arrow direction.
- Push in special tool 0 496 268 (11 0 390) and block the belt tensioner.
Follow-up work
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING THE COVER ON THE LEFT AND RIGHT IN THE ENGINE COMPARTMENT AT THE TOP .
- Refer to SECURING THE COOLANT EXPANSION TANK IN THE HOLDERS .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING BOTH FRONT-END STRUTS .